Labels: DOCUMENTED = taken from HP's manual; PROPOSED = our own joining or ordering of HP's directions, not an HP instruction; UNPERFORMED = a suggested check that has not been carried out.
Applies to
HP ProBook 430 G4. Confirm the exact model on the service label before starting.
HP ProBook 430 G4 display bezel, webcam/microphone module, and raw display panel replacement. HP prints this procedure on printed page 46 of its maintenance and service guide.
Tools and parts
- Screwdrivers and a non-marking pry tool as HP lists for this procedure
- Static-safe work surface
905801-001- Display panel assembly, touch; models without WWAN. Source: printed page 73.911830-001- Display panel assembly, touch; models with WWAN. Source: printed page 73.
Preparation
Save your work and shut the computer down through the operating system, unplug AC power and every external device, and work on a clean, grounded, ESD-protected surface while sorting each screw by its original location. Handle every cable by its connector and put each one back in its own place during reassembly.
Replacement
- Place the machine upright with the front toward you, and after that open it. (printed page 46).
- Flex the inside of the top edge (1) (printed page 46).
- Take out the display bezel (4). (printed page 46).
- To remove the webcam/microphone module: (printed page 46).
- To remove the display panel: (printed page 47).
- Fit the replacement part by working back through the printed removal steps (printed page 48).
Parts this procedure uses
- HP Touch display panel assembly for builds without the wide-are 905801-001 (905801-001)
- HP Touch display panel assembly for builds with the wide-area r 911830-001 (911830-001)
Manufacturer manual
HP Maintenance and Service Guide (PDF, HP). Machine-readable copy: /api/guides/hp-probook-430-g4-display-bezel-webcam-microphone-module-and-raw-display-panel-replace-p46