HP ProBook 440 G6 battery replacement

Step-by-step HP ProBook 440 G6 battery replacement paraphrased from HP's official Maintenance and Service Guide, with page citations.

Source: paraphrased from HP's official Maintenance and Service Guide (PDF, printed pages 31–38). Not bench-tested. We have not performed this repair; keep HP's manual open for its illustrations. Scope restrictions below are part of the guide: do not apply it to other models, generations or configurations. Service manuals are written for trained technicians; work at your own risk.

Labels: DOCUMENTED = taken from HP's manual; PROPOSED = our own joining or ordering of HP's directions, not an HP instruction; UNPERFORMED = a suggested check that has not been carried out.

Applies to

HP ProBook 440 G6. Confirm the exact model on the service label before starting.

This model uses Battery Safe mode and a battery-retaining tab. Do not substitute the cable-and-screw procedure from the EliteBook guides.

Tools and preparation

Phillips driver appropriate to the fasteners, nonmarking/nonconductive opening tool, static-safe work surface, and screw organizer. Advanced keyboard work requires all tools specified in the complete OEM manual.

Confirm the exact model is HP ProBook 440 G6. Save work, shut down through the operating system and disconnect external devices. Follow HP Battery Safe mode before opening: with the computer off and AC connected, press Windows + Backspace + Power; turn the computer on to initiate Battery Safe mode; after it powers off, disconnect AC (printed p. 36). In that mode it will not power on without AC. Use a grounded static-safe surface. Remove the two Phillips M2.0×5.0 cover screws and loosen the five captive Phillips screws. Starting under the display, use a nonconductive, nonmarking tool to release the cover; lift its rear and remove it (printed p. 37).

OEM spare options

Verify exact configuration before ordering. Table options do not establish blanket aftermarket upgrade compatibility.

  • L32656-002 — 3-cell, 45 Whr, 3.92 Ah battery; printed p. 38.

Procedure

  1. Remove the two Phillips M2.0×4.0 battery screws.
  2. Lift the top of the battery, then use a tool to push back the retaining tab at its bottom-left corner, following the diagram on printed page 38. Do not apply force to the battery enclosure.
  3. Lift out the battery.
  4. Install the replacement by reversing the illustrated removal, engaging its retaining tab and reinstalling the two battery screws.
  5. Refit the bottom cover, secure the five captive Phillips screws and reinstall the two M2.0×5.0 screws. Restore AC only after assembly.

After assembly

Suggested check, not performed: verify the replaced component is detected and functions. For an SSD, restore/migrate the OS and data using a separately prepared recovery plan; hardware replacement does not transfer data. After full reassembly, reconnect AC and press Power to leave Battery Safe mode (HP printed p. 36).

Part numbers in our catalog

Check each part page for its source and variant notes before ordering.

Official manual

HP Maintenance and Service Guide (PDF, HP). Machine-readable copy: /api/guides/hp-probook-440-g6-battery-replacement