Labels: DOCUMENTED = taken from HP's manual; PROPOSED = our own joining or ordering of HP's directions, not an HP instruction; UNPERFORMED = a suggested check that has not been carried out.
Applies to
HP EliteBook 840 G7. Confirm the exact model on the service label before starting.
HP EliteBook 840 G7 Notebook PC NFC module replacement. HP prints this procedure on printed page 53 of its maintenance and service guide, and the spare-part table for this part is on printed page 53.
tools and parts
- Screwdrivers and a non-marking pry tool as HP lists for this procedure
- Static-safe work surface
M07214-001- NFC module. Source: printed page 53.
preparation
Save your work and shut the computer down through the operating system, unplug AC power and every external device, and work on a clean, grounded, ESD-protected surface while sorting each screw by its original location. Handle every cable by its connector and put each one back in its own place during reassembly.
- Get the machine ready for taking apart (the Preparation for disassembly section is on page 33). (printed page 45).
- Take the bottom cover off (the Bottom cover section is on page 33). (printed page 45).
- Take the battery out (the Battery section is on page 43). (printed page 45).
replacement
- Detach the main board lead out of the ZIF connector on the NFC module (1). (printed page 53).
- Detach the touchpad lead out of the reverse ZIF connector at the NFC module (2). (printed page 53).
- Use a tool to free the unit (3), and after that take the unit from the machine (4). The unit is secured with adhesive. (printed page 53).
- Fit the replacement part by working back through the printed removal steps (printed page 53).
Parts this procedure uses
- HP NFC module M07214-001 (M07214-001)
Manufacturer manual
HP Maintenance and Service Guide (PDF, HP). Machine-readable copy: /api/guides/hp-elitebook-840-g7-nfc-module-replacement-p53