Labels: DOCUMENTED = taken from HP's manual; PROPOSED = our own joining or ordering of HP's directions, not an HP instruction; UNPERFORMED = a suggested check that has not been carried out.
Applies to
HP Fortis Flip G1i 11 inch Chromebook. Confirm the exact model on the service label before starting.
HP Fortis Flip G1i 11 inch Chromebook second camera module replacement. HP prints this procedure on printed page 45 of its maintenance and service guide.
Tools and parts
- Screwdrivers and a non-marking pry tool as HP lists for this procedure
- Static-safe work surface
N91928-001- Second camera module. Source: printed page 45.
Preparation
Save your work and shut the computer down through the operating system, unplug AC power and every external device, and work on a clean, grounded, ESD-protected surface while sorting each screw by its original location. Handle every cable by its connector and put each one back in its own place during reassembly.
Replacement
- Get the machine ready for taking apart (the Preparation for disassembly section is on page 28). (printed page 41).
- Take the bottom cover off (the Bottom cover section is on page 37). (printed page 29).
- Take the battery out (the Battery section is on page 28). (printed page 39).
- Take the two Phillips M2.0 × 3.0 fasteners (1) from the bracket over the unit, and after that take the bracket (2). (printed page 45).
- Lift up the unit (3) so you can access the connector underneath. (printed page 45).
- Detach the lead out of the reverse ZIF connector (4) at the camera module. (printed page 46).
Parts this procedure uses
- HP Camera module N91928-001 (N91928-001)
Manufacturer manual
HP Maintenance and Service Guide (PDF, HP). Machine-readable copy: /api/guides/hp-fortis-flip-g1i-11-inch-chromebook-second-camera-module-replacement-p45