Labels: DOCUMENTED = taken from HP's manual; PROPOSED = our own joining or ordering of HP's directions, not an HP instruction; UNPERFORMED = a suggested check that has not been carried out.
Applies to
HP ProBook 430 G3. Confirm the exact model on the service label before starting.
HP ProBook 430 G3 Notebook PC power cable replacement. HP prints this procedure on printed page 77 of its maintenance and service guide.
Tools and parts
- Screwdrivers and a non-marking pry tool as HP lists for this procedure
- Static-safe work surface
827039-001- Power connector and cable. Source: printed page 77.
Preparation
Save your work and shut the computer down through the operating system, unplug AC power and every external device, and work on a clean, grounded, ESD-protected surface while sorting each screw by its original location. Handle every cable by its connector and put each one back in its own place during reassembly.
Replacement
- Take out the 2 Phillips PM2.5×5.0 screws from the left display hinge. (printed page 77).
- Rotate the left display hinge upward (2). (printed page 77).
- Detach the cable from the system board (3). (printed page 77).
- Lift the cable off the clips around the fan (4) (printed page 78).
- Fit the replacement part by working back through the printed removal steps (printed page 78).
Parts this procedure uses
- HP Power connector cable 827039-001 (827039-001)
Manufacturer manual
HP Maintenance and Service Guide (PDF, HP). Machine-readable copy: /api/guides/hp-probook-430-g3-power-cable-replacement-p77