Labels: DOCUMENTED = taken from HP's manual; PROPOSED = our own joining or ordering of HP's directions, not an HP instruction; UNPERFORMED = a suggested check that has not been carried out.
Applies to
HP ProBook 430 G8. Confirm the exact model on the service label before starting.
HP ProBook 430 G8 Notebook PC display assembly replacement. HP prints this procedure on printed page 45 of its maintenance and service guide.
tools and parts
- Tweezers, Nonconductive, nonmarking pry tool and Magnetic Phillips P1 drivers
- Static-safe work surface
- No spare part number for this component was found in the cached manual
preparation
HP prints its tools list and its handling and electrostatic-discharge cautions on printed page 23. Its preparation for disassembly is on printed page 28: power the unit down through the operating system, unplug the power cord and detach every external device before opening it. Work on a grounded, static-safe surface, keep screws grouped by the position they came from, and handle boards and modules by their edges.
replacement
- If you need to remove bezel: a. Flex top (1), left and right sides (2), and then bottom of the bezel to release it. b. Take out the bezel from the display (4). (printed page 45).
- If the display panel has to come out: a. The panel is taped to the display enclosure under its left and right sides sides. Pull the tape out from behind the panel at each of its four corners. (printed page 45).
- Use following illustration to determine proper glue installation locations on display rear cover. Before installing display panel, be sure to connect display cable to the back of the panel. (printed page 47).
- If you need to remove the camera module: (printed page 47).
- If you need to remove camera privacy cover: (printed page 47).
- To remove remainder of display subcomponents, you must remove display assembly from computer. To remove display assembly, disconnect display cable from system board ZIF connector, and then remove cable from the clips in the fan (2). (printed page 48).
- Detach the antenna cables from the WLAN module (3). (printed page 48).
- Take out the five Phillips M2.5 × 4.0 screws that hold the display assembly to the computer. (printed page 48).
- Rotate the display to open the hinges (2). (printed page 48).
- Separate the display assembly from the computer (3). (printed page 49).
- If you need to remove hinges from the display enclosure: a. Take out the trim pieces (1). b. Take out the two Phillips M2.0 × 2.5 screws from each hinge. c. Take out the Phillips M2.5 × 4.0 screw from each hinge. (printed page 49).
- If you need to remove display panel/camera cable, peel cable up off the inside of the panel rear cover. (printed page 50).
- If you need to remove WLAN antennas and cables (printed page 50).
- Put the display assembly back by repeating the printed removal moves in the opposite order (printed page 50).
Part numbers in our catalog
- HP FHD 400 nit display panel (M24290-001)
- HP FHD 250 nit touch (TOP) display panel (M24291-001)
- HP FHD 250 nit display panel (M24293-001)
- HP FHD 1000 nit display panel (M24292-001)
- HP HD SVA 250 nit display panel (M24294-001)
- HP Screen M23558-001 (M23558-001)
Check each part page for its source and variant notes before ordering.
Manufacturer manual
HP Maintenance and Service Guide (PDF, HP). Machine-readable copy: /api/guides/hp-probook-430-g8-display-assembly-replacement-p45