Labels: DOCUMENTED = taken from HP's manual; PROPOSED = our own joining or ordering of HP's directions, not an HP instruction; UNPERFORMED = a suggested check that has not been carried out.
Applies to
HP ProBook 640 G2. Confirm the exact model on the service label before starting.
HP ProBook 640 G2 Notebook PC power button board replacement. HP prints this procedure on printed page 71 of its maintenance and service guide.
tools and parts
- Screwdrivers and a non-marking pry tool as HP lists for this procedure
- Static-safe work surface
preparation
Save your work and shut the computer down through the operating system, unplug AC power and every external device, and work on a clean, grounded, ESD-protected surface while sorting each screw by its original location. Handle every cable by its connector and put each one back in its own place during reassembly.
- Power the machine down. (printed page 38).
- Detach every external device wired to the machine. (printed page 39).
replacement
- Take the following parts out: a. Service door (the Service door section is on page 37). b. Take the battery out (the Battery section is on page 38) c. Hard drive (the Hard drive section is at page 39). d. Solid-state drive (see Solid-state drive (choose products only) at page 41). e. WWAN module (see WWAN module (choose products only) on page 42). (printed page 71).
- Fit the replacement part by working back through the printed removal steps (printed page 72).
Manufacturer manual
HP Maintenance and Service Guide (PDF, HP). Machine-readable copy: /api/guides/hp-probook-640-g2-power-button-board-replacement-p71