Labels: DOCUMENTED = taken from HP's manual; PROPOSED = our own joining or ordering of HP's directions, not an HP instruction; UNPERFORMED = a suggested check that has not been carried out.
Applies to
HP ZBook Studio G4. Confirm the exact model on the service label before starting.
HP ZBook Studio G4 Mobile Workstation bottom cover replacement. HP prints the spare part table for this procedure on printed page 29.
Tools and parts
- Flat-bladed screw driver, Magnetic screw driver and Phillips P0 and P1 screw drivers
- Static-safe work surface
922942-001- Bottom cover. Source: printed page 29.
Preparation
HP prints its tools list and its handling and electrostatic-discharge cautions on printed page 24. Work on a grounded, static-safe surface, keep screws grouped by the position they came from, and handle boards and modules by their edges.
Replacement
- Power the machine down. (printed page 29).
- Detach the power from the notebook by unplugging the power cord from the computer. (printed page 29).
- Detach all external devices from the computer. (printed page 29).
- Loosen the 4 captive Torx screws that hold the rear vent panel to the computer. (printed page 29).
- Lift the rear vent panel carefully off the computer (2). (printed page 30).
- Loosen the 7 captive Torx screws that hold the bottom cover to the computer. (printed page 30).
- Lift the bottom cover off the computer (2). (printed page 30).
- Install the bottom cover by working back through the printed removal steps (printed page 30).
Part numbers in our catalog
- HP bottom cover 922942-001 (922942-001)
Check each part page for its source and variant notes before ordering.
Manufacturer manual
HP Maintenance and Service Guide (PDF, HP). Machine-readable copy: /api/guides/hp-zbook-studio-g4-bottom-cover-replacement-p29