Labels: DOCUMENTED = taken from HP's manual; PROPOSED = our own joining or ordering of HP's directions, not an HP instruction; UNPERFORMED = a suggested check that has not been carried out.
Applies to
HP Chromebook G1m 11 inch. Confirm the exact model on the service label before starting.
HP Chromebook G1m 11 inch battery (revive kit) replacement. HP prints this procedure on printed page 26 of its maintenance and service guide.
Tools and parts
- Screwdrivers and a non-marking pry tool as HP lists for this procedure
- Static-safe work surface
N94727-001- Battery (the new battery that the revive kit carries). Source: printed page 26.
Preparation
Save your work and shut the computer down through the operating system, unplug AC power and every external device, and work on a clean, grounded, ESD-protected surface while sorting each screw by its original location. Handle every cable by its connector and put each one back in its own place during reassembly.
Replacement
- Disconnect the battery cable from the system board. (printed page 27).
- Open the empty battery containment tray. (printed page 28).
- Peel the paper backing layer off the adhesive on the tray. (printed page 28).
- Take out the two Phillips M2.0 × 3.5 screws (1) that hold the battery to the computer, under the tray. (printed page 28).
- Turn the tray (2) over so the adhesive faces down. (printed page 28).
- Set the tray (3) in the middle of the battery. (printed page 28).
- Press the indentations on the tray (4) so it sticks to the battery. (printed page 29).
- Undo the six M2.0 × 3.5 Phillips screws (1) that hold the battery in place. (printed page 29).
- Lift the top of the tray (2) to take the battery out of the computer. (printed page 29).
- Tilt the battery up and over so it sits in the cavity of the containment tray. (printed page 30).
- Open the containment tray that holds the new battery. (printed page 30).
- Turn the tray (1) over so the battery faces down, and lower the battery (2) into the computer; adhesive holds the battery to the tray. (printed page 30).
- Install the six Phillips screws (1) that secure the battery. (printed page 30).
- Lift the containment tray (2) off the battery. (printed page 30).
- Install the two remaining Phillips screws (3) that secure the battery. (printed page 31).
- Plug the battery cable back into the system board. (printed page 31).
Part numbers in our catalog
- HP battery N94727-001 (N94727-001)
Check each part page for its source and variant notes before ordering.
Manufacturer manual
HP Maintenance and Service Guide (PDF, HP). Machine-readable copy: /api/guides/hp-chromebook-g1m-11-inch-battery-revive-kit-replacement