Labels: DOCUMENTED = taken from HP's manual; PROPOSED = our own joining or ordering of HP's directions, not an HP instruction; UNPERFORMED = a suggested check that has not been carried out.
Applies to
HP EliteBook 640 G11. Confirm the exact model on the service label before starting.
HP EliteBook 640 14 inch G11 Notebook PC nfc module replacement. HP prints this procedure on printed page 80 of its maintenance and service guide.
Tools and parts
- Screwdrivers and a non-marking pry tool as HP lists for this procedure
- Static-safe work surface
914758-001- NFC module. Source: printed page 80.
Preparation
Save your work and shut the computer down through the operating system, unplug AC power and every external device, and work on a clean, grounded, ESD-protected surface while sorting each screw by its original location. Handle every cable by its connector and put each one back in its own place during reassembly.
Replacement
- Gently remove the protective tape (printed page 80).
- Detach the main board lead from the ZIF plug (2) on the top of the NFC module. (printed page 80).
- Detach the touchpad aerial lead from the ZIF plug (3) on the bottom of the NFC module. (printed page 80).
- Take out the NFC module from the computer. The module is held with adhesive. (printed page 81).
Parts this procedure uses
- HP NFC module 914758-001 (914758-001)
Manufacturer manual
HP Maintenance and Service Guide (PDF, HP). Machine-readable copy: /api/guides/hp-elitebook-640-14-inch-g11-nfc-module-replacement-p80