Labels: DOCUMENTED = taken from HP's manual; PROPOSED = our own joining or ordering of HP's directions, not an HP instruction; UNPERFORMED = a suggested check that has not been carried out.
Applies to
HP EliteBook 830 G11. Confirm the exact model on the service label before starting.
HP EliteBook 830 13 inch G11 Notebook PC nfc module replacement. HP prints this procedure on printed page 47 of its maintenance and service guide.
Tools and parts
- Screwdrivers and a non-marking pry tool as HP lists for this procedure
- Static-safe work surface
M08706-001- NFC module. Source: printed page 47.
Preparation
Save your work and shut the computer down through the operating system, unplug AC power and every external device, and work on a clean, grounded, ESD-protected surface while sorting each screw by its original location. Handle every cable by its connector and put each one back in its own place during reassembly.
Replacement
- Take out the protective tape (printed page 47).
- Detach the main board lead from the ZIF plug (2) on the top of the NFC module. (printed page 47).
- Detach the touchpad aerial lead from the ZIF plug (3) on the bottom of the NFC module. (printed page 48).
- Take out the NFC module from the computer. The module is held with adhesive. (printed page 48).
Parts this procedure uses
- HP NFC module M08706-001 (M08706-001)
Manufacturer manual
HP Maintenance and Service Guide (PDF, HP). Machine-readable copy: /api/guides/hp-elitebook-830-13-inch-g11-nfc-module-replacement-p47